When you install DL VST plugin in Foobar you can start Dirac Live application and it should accept VST plugin as Device. Next step is to install VST plugin within Foobar. When processor is being installed you will find DL plugin in C://Program files/Common files/ VST2 or VST3. You need to install Diral Live and Dirac Live processor of your choice (32bit/ 64 bit) first. I will load my project later, create a new filter and compare with the original made on the earlier Dirac version. They are very easy to compare in real time and at a consistent volume level. They all sounded excellent, differences were very subtle. When I did my original project, I measured three (same config - Sofa Narrow) and created a filter with each. But when listening critically there will be slight differences. They will of course sound extremely close and very different from no filter. Yes results from two projects (even in the same config) will vary very slightly, you can't really avoid it. Having said that, I see the new measurement produced same gain for the speakers, but bit different delay values. I remember Flavio told me once that does not really matter how exact you put the microphone, except for the sweet spot.Īnyway, my sofa has these sitting pillow so I put the mic kind of in between so it is more or less similar to what I did before. I measure 'Wide' arrangement, I have quite a bit sofa and there are 17? points. i don't know precisely where were the fixes, was it just during the last step of filter prep or also during measurements?īUT, I want to say that that's the point of Dirac - even though the placement varies a bit, result should be more or less the same, isn't it? I didn't re-measure as I wanted to conduct the full procedure to verify the new UI. Have you tried re-loading an existing project and creating a second filter with the new version for a like for like comparison? very frustratingīTW, multi-channel V2 was promised by January 2020ĭid you re-measure the a new project? if so, I would have thought it is likely to sound different because even with the best efforts, putting the mic in precisely the same spots as a previous project would be impossible. I restarted the computer, and thought I will be able to continue the measurement session in Dirac Live, but could not load the previously saved project.ģ) When I logout and login, I can't continue the session, is it by design? I see the files are stored on the disk, but Dirac Live is not using I would appreciate if you push this. Measurement session was over.Ģ) Knowing the measurement problems from the past, I saved the project all the time. With this new version, however, dead is dead. This behavior is not new to me, and I already opened a bug, but there was always a workaround - when I skipped the problematic point (this is random point, not some specific place in the room), move to the next one, measure it, and move back to the one I could not before - usually it succeeded. What happens is that I do hear the sweep signal, but the "EKG" on the screen is flat line, no measurements. I wanted to remeasure the room with the new Dirac Live (I already had V2, but from December), to my surprise I could not accomplish this □ġ) When I go through the measurement points, there is always one, for which I can't measure.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |